|
WaveCon ProCAP page 2 |
|
L-C FILTER SYNTHESIS A typical menu for bandpass filter design is shown below. A nodal file is also created.
PLOT CAPABILITY Two menus are available for plotting both two and three-port parameters. These include all of the S-Parameters, Gain/Loss, Phase, Group Delay, Noise Figure, Return Loss, VSWR, and Voltage Gain
LOG OR LINEAR SCALE Parameters may be plotted using either a linear or a log frequency scale.
S-CIRCLES When a transistor is used with noise parameters, noise circles and transducer input and output gain circles may be plotted.
SAVING PLOTS Plots may be saved as metafiles or selected into the clipboard as a bitmap.
NUMERICAL OUTPUTS Numerical output listing may be obtained for most parameters as S-Parameters, Y, Z, ABCD, and Impedance parameters for one, two and three-ports.
ELEMENTS More than 100 types of elements may be selected for the widest variety of designs. Most of the elements, found in other general analysis programs are also provided in ProCAP.
COLORS Colors for plots are menu selected. |
|
OPTIMIZATION When an element has been selected for tuning using ?, it may also be varied under circuit optimization. When the menu item Opt is selected a menu appears for defining optimization. When optimization is run, the program shows an error at the bottom of the screen which decreases as the circuit is optimized. When done, the plotted output and shows the final performance and updates the Circuit List.
EQUATE The menu item Equate is for setting two or more parameters equal to another parameter or for introducing an equation relating parameters mathematically.
MONTE CARLO A menu for Monte Carlo yield analysis may be selected. The results show the possible variation in circuit performance for element variations. Ranges for element variations are menu selected.
UNITS Units menu allows selection of GHz, MHz, or KHz for frequency. Length may be in inches, mils ,cm, or mm and Surface Roughness in microns or microinches. |
|
Diplexer Analysis
Diplexer Design |
